The origin is the starting and reference point from which you will frame and run your file. The origin will reflect the position of the small green square in your cut file from RD Works.
A membership or day pass is required to access the shop.
Laser 1 Shop Safety is required to use the Boss Laser Cutter.
Safety Check:
Sturdy, close-toed shoes must be worn at all times.
Long hair, jewelry, and loose clothing must be tied back.
Safety glasses and earmuffs must be worn while machines are running.
A dust mask or a NIOSH certified respirator is recommended.
For more information on shop safety visit Digital Fabrication under "Safety."
5 minutes
The origin is typically set in the upper right hand corner of your material.
The laser may or may not show a spot on your material to indicate where it is.
Even if you move the laser head around the bed, it will go back to this point when you start your file.
The laser head should remain over your material as it moves. If it doesn't, readjust your material until the laser head stays over the material.