Instructions to turn on the Boss laser cutters.
Safety Check:
Sturdy, close-toed shoes must be worn at all times.
Long hair, jewelry, and loose clothing must be tied back.
Safety glasses, earmuffs, and dust mask are recommended while the CNC Routers are running.
For more information on shop safety visit Digital Fabrication under "Safety."
< 5 mins.
Check with a Community Technician to make sure the air compressor has been turned on that day.
Verify that the laser exhaust system has been turned on for the day by checking that the switch outside the dust collection closet is set to 'ON'.
Verify that the chiller and exhaust blower are turned on by checking that the power strip located beside or behind the laser cutter is set to 'ON'.
If the blower or chiller do not turn on, or the chiller doesn't show a green light, find a Community Technician.
Disengage the E-stop by turning the red knob to the right. The knob is located on the machine’s top panel.
Use the Laser Cutter’s designated key to turn on the machine. The key control is located on the machine's top panel. The key can be checked out from the front desk.